Agilent Technologies InfiniiVision 3000 Programmer's Manual page 959

When the built- in waveform generator is licensed (Option WGN), you can
use it to output sine, square, ramp, pulse, DC, noise, sine cardinal,
exponential rise, exponential fall, cardiac, and gaussian pulse waveforms.
The :WGEN commands are used to select the waveform function and
parameters. See
Table 137 :WGEN Commands Summary
Command
:WGEN:ARBitrary:BYTeo
rder <order> (see
page 962)
:WGEN:ARBitrary:DATA
{<binary> | <value>,
<value> ...} (see
page 963)
n/a
:WGEN:ARBitrary:DATA:
CLEar (see page 965)
:WGEN:ARBitrary:DATA:
DAC {<binary> |
<value>, <value> ...}
(see page 966)
:WGEN:ARBitrary:INTer
polate {{0 | OFF} |
{1 | ON}} (see
page 967)
Agilent InfiniiVision 3000 X-Series Oscilloscopes
Programmer's Guide
32
:WGEN Commands
"Introduction to :WGEN Commands"
Query
:WGEN:ARBitrary:BYTeo
rder? (see page 962)
n/a
:WGEN:ARBitrary:DATA:
ATTRibute:POINts?
(see page 964)
n/a
n/a
:WGEN:ARBitrary:INTer
polate? (see
page 967)
s1
on page 961.
Options and Query Returns
<order> ::= {MSBFirst | LSBFirst}
<binary> ::= floating point
values between -1.0 to +1.0 in
IEEE 488.2 binary block format
<value> ::= floating point values
between -1.0 to +1.0 in
comma-separated format
<points> ::= number of points in
NR1 format
n/a
<binary> ::= decimal 16-bit
integer values between -512 to
+511 in IEEE 488.2 binary block
format
<value> ::= decimal integer
values between -512 to +511 in
comma-separated NR1 format
{0 | 1}
959