Sbus<N>:I2S:wslow - Agilent Technologies InfiniiVision 3000 Programmer's Manual

26
:SBUS<n> Commands
:SBUS<n>:I2S:WSLow
Command Syntax
:SBUS<n>:I2S:WSLow <low_def>
<low_def> ::= {LEFT | RIGHt}
The :SBUS<n>:I2S:WSLow command selects the polarity of the word select
(WS) signal:
• LEFT— a word select (WS) state of low indicates left channel data is
• RIGHt — a word select (WS) state of low indicates right channel data is
Query Syntax
:SBUS<n>:I2S:WSLow?
The :SBUS<n>:I2S:WSLow? query returns the currently selected I2S word
select (WS) polarity.
Return Format
<low_def><NL>
<low_def> ::= {LEFT | RIGHt}
See Also •
•
•
•
•
672
(see page 1088)
active on the I2S bus, and a WS state of high indicates right channel
data is active on the bus.
active on the I2S bus, and a WS state of high indicates left channel
data is active on the bus.
"Introduction to :TRIGger Commands"
":SBUS<n>:I2S:ALIGnment"
":SBUS<n>:I2S:CLOCk:SLOPe"
":SBUS<n>:I2S:RWIDth"
":SBUS<n>:I2S:TWIDth"
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
on page 843
on page 656
on page 658
on page 659
on page 671