Sbus<N>:M1553:Source - Agilent Technologies InfiniiVision 3000 Programmer's Manual

26
:SBUS<n> Commands
:SBUS<n>:M1553:SOURce
Command Syntax
:SBUS<n>:M1553:SOURce <source>
<source> ::= {CHANnel<n>}
<n> ::= 1 to (# analog channels) in NR1 format
The :SBUS<n>:M1553:SOURce command sets the source of the
MIL- STD 1553 signal.
Use the :TRIGger:LEVel:HIGH and :TRIGger:LEVel:LOW commands to set
the thresold levels for the selected source.
Query Syntax
:SBUS<n>:M1553:TRIGger:SOURce?
The :SBUS<n>:M1553:SOURce? query returns the currently set source of
the MIL- STD 1553 signal.
Return Format
<source><NL>
<source> ::= {CHAN<n>}
<n> ::= 1 to (# analog channels) in NR1 format
See Also
•
•
•
•
700
(see page 1088)
":TRIGger:LEVel:HIGH"
":TRIGger:LEVel:LOW"
":TRIGger:MODE" on page 851
"Introduction to :TRIGger Commands"
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
on page 849
on page 850
on page 843