Connect The Acx2200 Router To A Network For Out-Of-Band Management; Connect The Acx2200 Router To A Management Console Or Auxiliary Device; Connect Network Interface Cables To The Acx2200 Router - Juniper ACX2200 Quick Start Manual

Connect the ACX2200 Router to a Network for Out-of-Band Management

1. Turn off the power to the management device.
2. Plug one end of the Ethernet cable
on the front of the chassis.
3. Plug the other end of the cable into the network device.

Connect the ACX2200 Router to a Management Console or Auxiliary Device

1. Turn off the power to the console or auxiliary device.
2. Plug the RJ-45 end of the serial cable
CONSOLE/AUX port on the front panel.
3. Plug the female DB-9 end into the device's serial port.

Connect Network Interface Cables to the ACX2200 Router

1. Have ready a length of the type of cable used by the network ports. For cable specifications, see the
ACX2200 Universal Metro Routers Hardware Guide.
NOTE: Shielded cables are required for outside deployment.
2. Remove the rubber safety plug from the cable connector port.
WARNING:
fiber-optic cables. Fiber-optic transceivers and fiber-optic cables connected to a
transceiver emit laser light that can damage your eyes.
(Figure 8 on page 12
Figure 1 on page 4 shows the port.
(Figure 8 on page 12
Figure 1 on page 4
Do not look directly into a fiber-optic transceiver or into the ends of
shows the connector) into the MGMT port
shows the connector) into the
shows the port.
13