Table of Contents
Advertisement
Connecting the console cable and setting terminal
parameters
To access the router for the first time, use a console cable to connect the console port on the router.
Connecting the console cable
CAUTION:
The serial ports on PCs do not support hot swapping. To connect a PC to an operating router, first
connect the PC end. To disconnect a PC from an operating router, first disconnect the router end.
To connect the console cable:
Select a configuration terminal, which can be an ASCII terminal with an RS232 serial port or a
1.
PC. (A PC is more commonly used.)
Connect the DB-9 connector (female) of the console cable to the RS-232 serial port on the
2.
configuration terminal and the RJ-45 connector to the console port of the router.
Figure 18 Connecting the console cable
Setting configuration terminal parameters
To configure and manage the router through the console port, you must run a terminal emulator
program, TeraTermPro or PuTTY, on your PC. You can use the emulator program to connect a
network device, a Telnet site, or an SSH site. For more information about the terminal emulator
programs, see the user guides for these programs.
The following are the required terminal settings:
•
Baud rate—9600.
•
Data bits—8.
•
Stop bits—1.
•
Parity—None.
•
Flow control—None.
16
Advertisement
Table of Contents
