Time And Sntp Commands - D-Link xStack Reference Manual

xStack
The Simple Network Time Protocol (SNTP) (an adaptation of the Network Time Protocol (NTP)) commands in the
Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following table.
Command
config sntp
show sntp
enable sntp
disable sntp
config time
config time_zone
config dst
show time
Each command is listed, in detail, in the following sections.
config sntp
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure SNTP settings:
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
Parameters
{primary <ipaddr> | secondary <ipaddr> | poll-interval <int 30-99999>}
<date ddmthyyyy> <time hh:mm:ss>
{operator [+ | -] | hour <gmt_hour 0-13> | min <minute 0-59>}
[disable | repeating {s_week <start_week 1-4,last> | s_day <start_day sun-sat>|
s_mth <start_mth 1-12> | s_time <start_time hh:mm> | e_week <end_week 1-
4,last> | e-day <end_day sun-sat> | e_mth <end_mth 1-12> | e_time <end_time
hh:mm> | offset [30 | 60 | 90 | 120]} | annual {s_date <start_date 1-31> | s_mth
<start_mth 1-12> | s_time <start_time hh:mm> | e_date <end_date 1-31> |
e_mth <end_mth 1-12> | e_time <end_time hh:mm> | offset [30 | 60 | 90 | 120]}]
Used to setup SNTP service.
config sntp {primary <ipaddr> | secondary <ipaddr> | poll-interval <int 30-99999>}
Use this command to configure SNTP service from an SNTP server. SNTP must be
enabled for this command to function (See enable sntp).
primary − This is the primary server the SNTP information will be taken from.
•
primary server.
secondary − This is the secondary server the SNTP information will be taken from in the
event the primary server is unavailable.
•
secondary server.
poll-interval <int 30-99999> − This is the interval between requests for updated SNTP
information. The polling interval ranges from 30 to 99,999 seconds.
Only Administrator and Operator-level users can issue this command. SNTP service
must be enabled for this command to function (enable sntp).

TIME AND SNTP COMMANDS

689
<ipaddr> − The IP address of the
<ipaddr> − The IP address for the
95