D-Link xStack Reference Manual page 523

xStack
debug ospf interface_state_change
Parameters
Restrictions
Example usage:
To enable OSPF interface state change debug:
DGS-3627:admin# debug ospf interface_state_change state enable
Command: debug ospf interface_state_change state enable
Success.
DGS-3627:admin#
debug ospf lsa
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable all OSPF LSA debug flags:
DGS-3627:admin# debug ospf lsa all state enable
Command: debug ospf lsa all state enable
Success.
DGS-3627:admin#
debug ospf packet
Purpose
Syntax
Description
Parameters
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
change.
dr_bdr_selection - Used to include or exclude debug information for DR/BDR selection.
state - The state of the OSPF interface state change debug.
Only Administrator level users can issue this command.
Used to enable or disable debug information flags about LSA.
debug ospf lsa {all | originating | installing | receiving | flooding} state [enable |
disable]
This command is used to enable or disable debug information flags about LSA.
all - Set all LSA debug flags.
originating - Set LSA originating debug flag.
installing - Set LSA installing debug flag.
receiving - Set LSA receiving debug flag.
flooding - Set LSA flooding debug flag.
state - The state of the designated debug flag.
Only Administrator level users can issue this command.
Used to enable or disable debug information flags about packets, including receiving and
sending.
debug ospf packet {all | receiving | sending} state [enable | disable]
This command is used to enable or disable debug information flags about packets, including
receiving and sending.
all - Set all packet debug flags.
receiving - Set packet receiving debug flag.
519