D-Link xStack Reference Manual page 657

xStack
This example shows how to create an IPv6 subnet VLAN entry:
DGS-3627:admin# create subnet_vlan ipv6network FE80::/64 vlan v2 priority 2
Command: create subnet_vlan ipv6network FE80::/64 vlan v2 priority 2
Success.
DGS-3627:admin#
delete subnet_vlan
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
This example shows how to delete a subnet VLAN entry:
DGS-3627:admin# delete subnet_vlan network 172.168.1.0/24
Command:delete subnet_vlan network 172.168.1.0/24
Success.
DGS-3627:admin#
This example shows how to delete all subnet VLAN entries:
DGS-3627:admin# delete subnet_vlan all
Command:delete subnet_vlan all
Success.
DGS-3627:admin#
show subnet_vlan
Purpose
Syntax
Description
Parameters
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
Use this command to delete subnet vlan entry.
delete subnet_vlan [network <network_address> | ipv6network <ipv6networkaddr>] |
vlan <vlan_name 32> | vlanid <vidlist>| all]
This command is used to delete subnet vlan entry from switch. You can delete subnet vlan
entry by IP subnet or vlan, or delete all subnet vlan entries.
network - To specify an IPv4 network address or IPv6 network addres. The format is
ipaddress / prefix length.
ipv6network - To specify an IPv6 network address. The format is ipaddress / prefix
length.The prefix length of IPv6 network address shall not be greater than 64.
vlan - If specify the vlan, all subnet vlan entries that associated with this vlan will be deleted.
vidlist - Specifies a list of VLANs by VLAN ID.
all - If specify all, all subnet vlan entries will be deleted.
Only Administrator and Operator-level users can issue this command.
Use this command to display subnet vlan entry information.
show subnet_vlan {[network<network_address> | ipv6network <ipv6networkaddr>] |
vlan <vlan_name 32> | vlanid <vidlist>]}
This command is used to display subnet vlan entry information.
network - To specify an IPv4 network address. If network address is not specifed, all subnet
653