D-Link xStack Reference Manual page 123

xStack
delete bgp network
Parameters
Restrictions
Example usage:
To delete network 10.108.0.0/16 to be advertised in the BGP updates:
DGS-3627:admin# delete bgp network 10.108.0.0/16
Command: delete bgp network 10.108.0.0/16
Success.
DGS-3627:admin#
show bgp network
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To show network 10.108.0.0/16 advertised in the BGP updates:
DGS-3627:admin# show bgp network 10.108.0.0/16
Command: show bgp network 10.108.0.0/16
Network Address
-----------------
10.108.0.0/16
Total Network Number:
DGS-3627:admin#
config bgp timer
Purpose
Syntax
Description
Parameters
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
<network_address> - Represents the local network that BGP will advertise.
all - Deletes all BGP networks.
Only Administrator and Operator-level users can issue this command.
This command is used to show the networks advertised by the Border Gateway Protocol
(BGP).
show bgp network {<network_address>}
This command used to show the networks advertised by BGP.
<network_address> - Represents the local network that BGP will advertise.
If a specific network address is not specified, all network addresses will be displayed.
Only Administrator and Operator-level users can issue this command.
Route Map
-------------
-
1
This command is used to configure the BGP protocol timer.
config bgp timer holdtime <sec 0-65535> keepalive <sec 0-65535>
This command is used to configure the BGP protocol timer.
The hold time needs to be at least three times that of the keepalive time.
If the timer is specified for specific neighbors, then the neighbor specific timer will take effect.
holdtime - The valid values are from 0 to 65535.
The system will declare a peer as dead if a keepalive message is received that is
more than the hold time.
119