D-Link xStack Reference Manual page 105

xStack
After configuring BGP to enable the error debug flag, it may print following information when an error happens:
BGP: 10.1.1.1-10.2.2.2, NHop Validate: Invalid NHop address 250.3.0.0/8 received.
BGP: Hold-Timer: Invalid Peer.
debug bgp show global_info
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
Configure BGP to show global information:
DGS-3627:admin# debug bgp show global_info
Command: debug bgp show global_info
Following is the information for global debugging:
---------------------------------------------------
AS Number
Router ID
Cluster ID
Confed ID
Confederation peers
Fast External Fallover
Graceful Restart
Restart Time
Stalepath Time
Update Delay Time
Dampening ability
Client to Client ability
Cluster peers are:
Aggregate Next_Hop_Check
Default Local Preference
Default Holdtime
Default Keepalive
Scan Time
BGP active flag:
BGP active af-flag is:
BGP_AF_CFLAG_NETWORK_SYNC
note: address family is IPv4 Unicast
BGP active Redist-Flags:
note: The address family is IPv4
BGP Trap
DGS-3627:admin#
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
This command is used to display global information of the current BGP instance.
debug bgp show global_info
This command is used to display global information of the current BGP instance.
None.
Only Administrator level users can issue this command.
: 10000
: 192.168.60.105
: 0.0.0.0
: 0
:
: Enabled
: Disabled
: 120 Seconds
: 360 Seconds
: 120 Seconds
: Disabled
: Enable
: Disabled
: 100
: 180
: 60
: 60
: None
101