D-Link xStack Reference Manual page 571

xStack
config port dot1v
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To bind a VLAN with a protocol template:
DGS-3627:admin# config port dot1v ports 1:6-1:8 add protocol_group group_id 1 vlan
building1
Command: config port dot1v ports 1:6-1:8 add protocol_group group_id 1 vlan building1
Success.
DGS-3627:admin#
show port dot1v
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the ports for a protocol VLAN group:
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
Used to bind a VLAN with a protocol template on one or more ports.
config port dot1v ports [<portlist> | all] [add protocol_group group_id <id> [vlan <
vlan_name 32> | vlanid <vlanid>] | delete protocol_group [group_id <id> | all]]
This command will bind a VLAN with a protocol template on one or more ports. When an
ingress untagged packet is identified by the protocol_value stated using the config
dot1v_protocol_group command, the switch will assign a pre-configured VLAN and a priority
for these ingress untagged packets in order to properly reach their destination.
ports – Use this parameter to specify ports.
• <portlist> − Use this parameter to assign a port or group of ports.
•
all – Use this parameter to specify all ports on the system.
add protocol_group group_id <id> − Enter an integer from 1 to 16 to identify the protocol VLAN
group being assigned to the ports or range of ports configured in the previous field.
vlan – Use this parameter bind a VLAN with a specific protocol template using either of the
following parameters:
• vlan_name 32 − Identify the VLAN name for which to add a tag to ingress untagged
packets.
•
vlanid - Identify the VID for which to add a tag to ingress untagged packets.
delete protocol_group – Use this parameter to remove this protocol VLAN group's association
with the ports stated in this command, by using the following parameters:
• group_id <id> − Enter this parameter with its corresponding group number, to remove
this pre-defined protocol group from the ports specified here.
•
all – Use this parameter to remove all protocol VLAN groups from the ports specified
in this command.
Only Administrator and Operator-level users can issue this command.
Used to display the bound protocol template on a specific port or ports.
show port dot1v {ports <portlist>}
This command will display the protocol VLAN group and VLAN for individual ports.
ports <portlist> − Enter the port or group of ports for which to display the protocol VLAN group
settings. Entering this command without this parameter will display all ports and their
corresponding protocol VLAN group settings.
None.
567