D-Link xStack Reference Manual page 606

xStack
debug ripng state
Restrictions
Example usage:
To enable RIPng debug globally:
DGS-3627:admin# debug ripng state enable
Command: debug ripng state enable
Success.
DGS-3627:admin#
debug ripng show flag
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To show the current RIPng debug flag setting:
DGS-3627:admin# debug ripng show flag
Command: debug ripng show flag
Current Enabled RIPng Flags:
Interface State Change
Packet Receiving
Packet Sending
Route
DGS-3627:admin#
debug ripng flag
Purpose
Syntax
Description
Parameters
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
Only Administrator and Operator-level users can issue this command.
This command is used to display the RIPng debug flag setting.
debug ripng show flag
Used to display the RIPng debug flag setting.
None.
Only Administrator and Operator-level users can issue this command.
This command is used to enable or disable the RIPng debug flag .
debug ripng flag [{interface | packet [all | rx | tx] | route}(1) | all] state [enable | disable]
Used to enable or disable the RIPng debug flag.
interface - The state of the RIPng interface debug. The default setting is disabled.
packet - See below:
all - Set all packets with debug flags.
rx - Set inbound packets with debug flag.
tx - Set outbound packets with debug flag.
route - The state of the RIPng route debug. The default setting is disabled.
all - Set all debug flags.
state - See below:
enable - Enable the designated flags.
602