D-Link xStack Reference Manual page 334

xStack
The Internet Group Management Protocol (IGMP) commands in the Command Line Interface (CLI) are listed (along with
the appropriate parameters) in the following table.
Command
config igmp
show igmp
show igmp group
config igmp
check_subscriber_source_network
show igmp
check_subscriber_source_network
Each command is listed, in detail, in the following sections.
config igmp
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the IGMP for the IP interface "System":
DGS-3627:admin# config igmp ipif System version 1 state enable
Command: config igmp ipif System version 1 state enable
Success.
DGS-3627:admin#
To configure the IGMPv2 for all IP interfaces:
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
Parameters
[ipif <ipif_name 12>|all] { version <value 1-3> | query_interval <sec 1-31744> |
max_response_time <sec 1-25> | robustness_variable <value 1-255> |
last_member_query_interval <value 1-25> | state [enable | disable]}
{ipif <ipif_name 12>}
{group <group>} {ipif <ipif_name 12>}
[ ipif <ipif_name 12> | all ] [ enable | disable ]
{ipif <ipif_name 12>}
This command is used to configure IGMP on the switch.
config igmp [ipif <ipif_name 12>|all] { version <value 1-3> | query_interval <sec 1-
31744> | max_response_time <sec 1-25> | robustness_variable <value 1-255> |
last_member_query_interval <value 1-25> | state [enable | disable]}
The config igmp command is used to configure IGMP on switch.
ipif_name - The name of the IP interface for which you want to configure IGMP.
all - Specifies all the IP interfaces on the switch.
version - IGMP version. The default value is 3.
query_interval - The time in seconds between general query transmissions. The default value
is 125.
max_response_time - The maximum time in seconds to wait for reports from members. The
default value is 10.
robustness_variable - The permitted packet loss that guarantees IGMP. The default value is
2.
last_member_query_interval - Max Response Time inserted into Group-Specific Queries sent
in response to Leave Group messages, and is also the amount of time between Group-
Specific Query messages. The default setting is 1.
state - Enable or disable IGMP on a router interface.
Only Administrator and Operator-level users can issue this command.
330