D-Link xStack Reference Manual page 435

xStack
show loopdetect ports
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To show the LBD settings on ports 1-9:
DGS-3627:admin# show loopdetect
Command: show loopdetect
Port Loopdetect State
------ ------------------ ----------
1 Enabled
2 Enabled
3 Enabled
4 Enabled
5 Enabled
6 Enabled
7 Enabled
8 Enabled
9 Enabled
DGS-3627:admin#
config loopdetect trap
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To specify that traps will be sent when the loop condition is detected or cleared:
DGS-3627:admin# config loopdetect trap both
Command: config loopdetect trap both
Success.
DGS-3627:admin#
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
This command is used to display the LBD per-port configuration.
show loopdetect ports {<portlist>}
This command is used to display the LBD per-port configuration.
ports - Specify the range of member ports that will display the LBD settings.
<portlist> - Enter the list of port to be configured here.
If no port is specified, the configuration for all ports will be displayed.
None.
ports 1-9
ports 1-9
Loop Status
Normal
Normal
Normal
Normal
Loop!
Normal
Loop!
Normal
Normal
This command is used to configure the trap modes for LBD.
config loopdetect trap [none | loop_detected | loop_cleared | both]
This command is used to configure the trap modes for LBD.
none - There is no trap in the LBD function.
loop_detected - Trap will only be sent when the loop condition is detected.
loop_cleared - Trap will only be sent when the loop condition is cleared.
both - Trap will either be sent when the loop condition is detected or cleared.
Only Administrator and Operator-level users can issue this command.
431