D-Link xStack Reference Manual page 427

xStack
config lldp forward_message
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure LLDP forward_message:
DGS-3627:admin# config lldp forward_message enable
Command: config lldp forward_message enable
Success.
DGS-3627:admin#
show lldp
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the LLDP system level configuration status:
DGS-3627:admin# show lldp
Command: show lldp
LLDP System Information
Chassis ID Subtype
Chassis ID
System Name
System Description
System Capabilities
LLDP Configurations
LLDP Status
LLDP Forward Status
Message Tx Interval
Message Tx Hold Multiplier: 4
ReInit Delay
Tx Delay
Notification Interval
DGS-3627:admin#
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
Used to configure the forwarding of LLDPDU packets when LLDP is disabled.
config lldp forward_message [enable | disable]
When LLDP is disabled and LLDP forward_message is enabled, the received LLDPDU
packets will be forwarded. The default state is disabled.
None.
Only Administrator and Operator-level users can issue this command.
This command displays the switch's general LLDP configuration status.
show lldp
This command displays the switch's general LLDP configuration status.
None.
None.
: MAC Address
: 00-19-5B-F5-26-C0
:
: Gigabit Ethernet Switch
: Repeater, Bridge
: Disabled
: Disabled
: 30
: 2
: 2
: 5
423