D-Link xStack Reference Manual page 716

xStack
DGS-3627:admin# show iproute
Command: show iproute
Routing Table
IP Address/Netmask
------------------
10.1.1.0/24
192.168.1.0/24
Total Entries : 2
DGS-3627:admin# show iproute static
Command: show iproute static
Routing Table
IP Address/Netmask
------------------
0.0.0.0/0
100.1.1.0/24
101.1.1.0/24
Total Entries : 3
DGS-3627:admin# show iproute hardware
Command: show iproute hardware
Routing Table
IP Address/Netmask
------------------
0.0.0.0/0
10.1.1.0/24
100.1.1.0/24
192.168.1.0/24
Total Entries : 4
DGS-3627:admin#
config route preference
Purpose
Syntax
Description
Parameters
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
Gateway Interface
--------------- ------------
0.0.0.0
0.0.0.0
Gateway Cost
------------- -----
10.1.1.11
10.1.1.11
10.1.1.12
Gateway Interface
--------------- ------------
10.1.1.11
0.0.0.0
10.1.1.11
10.1.1.11
Used to configure route type preference.
config route preference [static | default | rip | ospfIntra | ospfInter | ospfExt1 | ospfExt2
| ebgp | ibgp] <value 1-999>
Use this command to configure route preference. The route with smaller preference has
higher priority. The preference for local routes is fixed to 0.
static - Configure the preference of static route. The default value is 60.
default - Configure the preference of default route. The default value is 1.
rip - Configure the preference of RIP route. The default value is 100.
ospfIntra - Configure the preference of OSPF intra-area route. The default value is 80.
ospfInter - Configure the preference of OSPF inter-area route. The default value is 90.
ospfExt1 - Configure the preference of OSPF external type-1 route. The default value is 110.
Cost
--------
System
ip1
Protocol Backup
-------- --------
1 Default
1 Static Primary
1 Static Primary
ip1
System
ip1
ip1
712
Protocol
--------
1 Local
1 Local
Weight Status
------ --------
Primary None
None Active
None Inactive
Active