D-Link xStack Reference Manual page 479

xStack
show stp ports
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To show stp ports:
DGS-3627:admin# show stp ports
Command: show stp ports
MSTP Port Information
Port Index : 1
External PathCost : Auto/20000
Port RestrictedRole : False,
Port Forward BPDU : Disabled
Msti Designated Bridge
----- ------------------
0 N/A
2 N/A
DGS-3627:admin#
show stp mst_config_id
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
show stp mst_config_id:
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
Used to show the port information includes parameters setting and operational value.
show stp ports {<portlist>}
This command displays each port's parameters settings. If not input the portlist, all ports will
be shown . If there are multi instances on this bridge , the parameters of the port on different
instances will be shown.
ports - To show parameters of the designated port numbers , to be distinguish ed from
showing parameters of the bridge.
portlist - One of CLI Value Type , restrict the input value and format of the ports, refer to
section 1-4 Switch Numerical Ranges.
instance_id - specifies the stp instance id.
None.
, Hello Time: 2 /2 , Port STP : Enabled
, Edge Port : False/No , P2P : Auto /Yes
Port RestrictedTCN : False
Internal PathCost
-----------------
200000
200000
Used to show the MST Configuration Identification.
show stp mst_config_id
Show the 3 elements of the MST configuration Identification, including: Configuration
NameRevision Level, and MST configuration Table. The default Configuration name is the
MAC address of the bridge.
mst_config_id - If two bridges has the same three elements in mst_config_id, that means
they are in the same MST region.
None.
Prio Status
---- ----------
128 Disabled
128 Disabled
475
, LBD : No
Role
----------
Disabled
Disabled