D-Link xStack Reference Manual page 108

xStack
debug bgp show peer group
Parameters
Restrictions
Example usage:
Configure BGP to show the peer group's configuration:
DGS-3627:admin# :5#debug bgp show peer_group
Command: debug bgp show peer_group
BGP Peer Group :local1
-----------------------------------------------------------------------
Session State : Enabled
Session Activity : Enabled
Members : 192.168.6.102
Remote AS : Not Set
Holdtime Interval : 180 seconds
Keepalive Interval : 60 seconds
Advertisement Interval : 0 seconds
AS Origination Interval : 0 Seconds
Connect Retry Interval : 0 Seconds
EBGP Multihop : 1
Weight : 0
Next Hop Self : Disabled
Remove Private As : Disabled
Allowas In : Disabled
Graceful Restart : Disabled
Soft Reconfiguration Inbound : Disabled
Community Sent to this Neighbor : None
Default Originate : Disabled
Capability 0rf Prefix List : None
Prefix max count: 12000
Prefix warning threshold: 75
Prefix max warning: Disabled
DGS-3627:admin#
debug bgp show network
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
Configure BGP to show the current network information:
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
None.
Only Administrator level users can issue this command.
This command is used to display the current network's configuration in the BGP protocol
stack.
debug bgp show network
This command is used to display the current network's configuration in the BGP protocol
stack.
None.
Only Administrator level users can issue this command.
104