Syslog Or Trap Source-Interface Commands - D-Link xStack Reference Manual

xStack

SYSLOG OR TRAP SOURCE-INTERFACE COMMANDS

The syslog or trap source-interface function is used for selecting a fixed interface as the source interface to send syslog
or trap message. It also provides a mechanism to select a certain IP address from the specified interface as the source
address to send the message. The servers beyond different networks receive the syslog or trap message always come
from a fixed source IP address, it is helpful to use the source IP address to identify the switch.
The Syslog or Trap Source-Interface commands in the Command Line Interface (CLI) are listed (along with the
appropriate parameters) in the following table.
Command
config syslog source_ipif
show syslog source_ipif
config trap source_ipif
show trap source_ipif
Each command is listed, in detail, in the following sections.
config syslog source_ipif
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
Configure syslog source IP interface:
DGS-3627:admin# config syslog source_ipif ipif3 14.0.0.5
Command: config syslog source_ipif ipif3 14.0.0.5
Success
DGS-3627:admin#
To clear the configured source IP interface for syslog:
DGS-3627:admin# config syslog source_ipif none
Command: config syslog source_ipif none
Success
DGS-3627:admin#
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
Parameters
[<ipif_name> {<ipaddr>} | none]
[<ipif_name> {<ipaddr> | <ipv6addr>} | none]
Configure syslog source IP interface.
config syslog source_ipif [<ipif_name> {<ipaddr>} | none]
This command is used to configure syslog source IP interface.
ipif_name - IP interface name. If only specify this parameter, the least IPv4 address and the
smallest IPv6 address of ipif_name will be used as source IP addresses.
none - For clear the configured source IP interface.
ipaddr - Specify the IPv4 address.
Only Administrator and Operator-level users can issue this command.
666
90