Ip Multicasting Commands - D-Link xStack Reference Manual

xStack
The IP multicasting commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in
the following table.
Command
show ipmc cache
show ipmc
Each command is listed, in detail, in the following sections.
show ipmc cache
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the current IP multicast forwarding cache:
DGS-3627:admin# show ipmc cache
Command: show ipmc cache
Multicast Source Address/Netmask
Group
--------------- ----------------------
224.1.1.1 10.48.74.121/32
224.1.1.1 20.48.74.25 /32
224.1.2.3 10.48.75.3 /3
Total Entries: 3
DGS-3627:admin#
show ipmc
Purpose
Syntax
Description
Parameters
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
Parameters
{group <group>} {ipaddress <network_address>}
{ipif <ipif_name 12> | protocol [inactive | dvmrp | pim]}
Used to display the current IP multicast forwarding cache.
show ipmc cache {group <group>} {ipaddress <network_address>}
This command will display the current IP multicast forwarding cache.
group <group> − The multicast group IP address.
ipaddress <network_address> − The IP address and netmask of the source. The address and
mask information can be specified using the traditional format (for example, 10.1.2.3/255.0.0.0
or in CIDR format, 10.1.2.3/8).
None.
Used to display the IP multicast interface table.
show ipmc {ipif <ipif_name 12> | protocol [inactive | dvmrp | pim]}
This command will display the current IP multicast interface table.
<ipif_name 12> − The name of the IP interface for which to display the IP multicast

IP MULTICASTING COMMANDS

Upstream Expire
Neighbor Time
------------- ------
10.48.75.63 30
20.48.75.25 20
10.48.76.6 30
336
44
Routing
Protocol
--------
DVMRP
DVMRP
DVMRP