D-Link xStack Reference Manual page 417

xStack
Command
enable lldp
disable lldp
config lldp
config lldp
config lldp
config lldp
config lldp
config lldp ports
config lldp ports
config lldp ports
config lldp ports
config lldp ports
config lldp ports
config lldp ports
config lldp ports
config lldp ports
config lldp
show lldp
show lldp mgt_addr
show lldp ports
show lldp local_ports
show lldp remote_ports
show lldp statistics
show lldp statistics ports
Each command is listed, in detail, in the following sections.
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
Parameters
message_tx_interval <sec 5-32768>
message_tx_hold_multiplier <int 2–10>
tx_delay <sec 1-8192>
reinit_delay <sec 1-10>
notification_interval <sec 5-3600>
[<portlist>|all] notification [enable | disable]
[<portlist>|all] admin_status [tx_only | rx_only | tx_and_rx | disable]
[<portlist>|all] mgt_addr [ipv4 <ipaddr> | ipv6 <ipv6addr>] [enable | disable]
[<portlist>|all] basic_tlvs [all | {port_description | system_name |
system_description | system_capabilities}] [enable | disable]
[<portlist>|all] dot1_tlv_pvid [enable | disable]
[<portlist>|all] dot1_tlv_protocol_vid [vlan [all | <vlan_name 32> ] | vlanid <vidlist> ]
[enable | disable]
[<portlist>|all] dot1_tlv_vlan_name [vlan [all | <vlan_name 32> ] | vlanid <vidlist> ]
[enable | disable]
[<portlist>|all] dot1_tlv_ protocol_identity[all | { eapol | lacp | gvrp | stp}] [enable |
disable]
[<portlist>|all] dot3_tlvs [all | {mac_phy_configuration_status | link aggregation |
maximum_frame_size}] [enable | disable]
forward_message [enable | disable]
{[ipv4 <ipaddr> | ipv6 <ipv6addr>]}
{<portlist>}
{<portlist>} {mode [brief | normal | detailed]}
{<portlist>} {mode [brief | normal | detailed]}
{<portlist>}
413