D-Link xStack Reference Manual page 517

xStack
show ospf ipif
Description
Parameters
Restrictions
Example usage:
To display the current OSPF interface settings, for a specific OSPF interface:
DGS-3627:admin# show ospf ipif System
Command: show ospf ipif System
Interface Name: System
Network Medium Type: BROADCAST
Area ID: 0.0.0.0
Priority: 1
DR Address: None
Hello Interval: 10
Transmit Delay: 1
Authentication: None
Passive Mode: Disabled
Total Entries: 1
DGS-3627:admin#
show ospf all
Purpose Used to display the current OSPF settings of all the OSPF interfaces on the Switch.
Syntax show ospf all
Description This command will display the current OSPF settings for all OSPF interfaces on the Switch.
Parameters None.
Restrictions None.
Example usage:
To display the current OSPF interface settings, for all OSPF interfaces on the Switch:
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
This command will display the current OSPF interface settings for the specified interface
name.
<ipif_name 12> − The IP interface name for which to display the current OSPF interface
settings.
all – Choosing this parameter will display the OSPF settings for all IP interfaces on the
Switch.
None.
IP Address: 172.18.70.105/21 (Link Up)
Metric: 1
Administrative State: Disabled
DR State: DOWN
Backup DR Address: None
Dead Interval: 40
Retransmit Time: 5
513