D-Link xStack Reference Manual page 725

xStack
config ecmp algorithm
Restrictions
Example usage:
To set the ECMP hash algorithm:
DGS-3627:admin# config ecmp algorithm ip_destination ip_source
Command: config ecmp algorithm ip_destination ip_source
Success.
DGS-3627:admin#
show ecmp
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the ECMP hash algorithm:
DGS-3627:admin# show ecmp
Command: show ecmp
ECMP For OSPF: Enabled
ECMP Load Balance Algorithm:
Destination IP: Used.
Source IP: Not Used.
CRC_Low: Used.
CRC_High: Not Used.
TCP_UDP_Port: Not Used.
DGS-3627:admin#
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
excluded. It it set by default.
crc_high - If set, the ecmp algorithm will include the upper 5 bits of the CRC. This attribution
is mutually exclusive with ip_source and crc_low. If it is set, crc_low and ip_source will be
excluded. It is not set by default.
tcp_udp_port - If set, the ecmp algorithm will include the TCP or UDP port. It is not set by
default.
Only Administrator and Operator-level users can issue this command.
Used to display the ECMP route load-balancing algorithm.
show ecmp
This command is used to display the ECMP route load-balancing algorithm.
None.
None.
721