D-Link xStack Reference Manual page 745

xStack
enable wac
Description
Parameters
Restrictions
Example usage:
To enable WAC:
DGS-3627:admin# enable wac
Command: enable WAC
Success.
DGS-3627:admin#
disable wac
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To disable WAC:
DGS-3627:admin# disable wac
Command: disable wac
Success.
DGS-3627:admin#
config wac ports
Purpose
Syntax
Description
Parameters
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
The enable wac command enables WAC function.
WAC and JWAC are mutual exclusive function. That is, they can not be enabled at the same
time.
None.
Only Administrator and Operator-level users can issue this command.
Used to disable WAC function.
disable wac
The disable wac command disables WAC function; all authentication entries related to WAC
will be deleted.
None.
Only Administrator and Operator-level users can issue this command.
Used to config state and other parameters of the ports.
config wac ports [<portlist> | all] {state [enable | disable] | aging_time [infinite | <min 1-
1440>] | idle_time [infinite | <min 1-1440>] | block_time [<sec 0-300>]}(1)
The config wac ports command allows you to configure port state and other parameters of
WAC.
The default value of aging time is 1440 minutes.
The default value of idle time is infinite.
The default value of block_time is 60 seconds.
portlist - A port range to set their WAC state.
all - All the Switch ports' WAC state is to be configured.
state - To specify the port state of WAC
741