D-Link xStack Reference Manual page 302

xStack
Example usage:
To set the ingress checking status, the sending and receiving GVRP information :
DGS-3627:admin# config gvrp 1:1-1:4 state enable ingress_checking enable acceptable_frame
tagged_only pvid 2
Command: config gvrp 1:1-1:4 state enable ingress_checking enable acceptable_frame
tagged_only pvid 2
Success.
DGS-3627:admin#
NOTE: When the PVID Auto Assign function is disabled, users must manually configure the PVID
for untagged ports or the host may not connect to the Switch correctly.
enable gvrp
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable the generic VLAN Registration Protocol (GVRP):
DGS-3627:admin# enable gvrp
Command: enable gvrp
Success.
DGS-3627:admin#
disable gvrp
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
Used to enable GVRP on the Switch.
enable gvrp
This command, along with disable gvrp below, is used to enable and disable GVRP
globally on the Switch, without changing the GVRP configuration on the Switch.
None.
Only Administrator and Operator-level users can issue this command.
Used to disable GVRP on the Switch.
disable gvrp
This command, along with enable gvrp above, is used to enable and disable GVRP on the
Switch, without changing the GVRP configuration on the Switch.
None.
Only Administrator and Operator-level users can issue this command.
298