Telnet Client Commands - D-Link xStack Reference Manual

xStack
The Telnet Client commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in
the following table.
Command
telnet
Each command is listed, in detail, in the following sections.
telnet
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
Telnet to a Switch by specifying the IP address:
DGS-3627:admin# telnet 10.90.90.90
Command: telnet 10.90.90.90
Copyright(C) 2006-2010 D-Link Corporation. All rights reserved.
UserName:
Telnet to a host by specifying the domain name and the server port:
DGS-3627:admin# telnet ctrl.iplanet.org tcp_port 2323
Command: telnet ctrl.iplanet.org tcp_port 2323
Login:
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
Parameters
[<ipaddr> | <domain_name 255>] {tcp_port(1) <value 0-65535>}
Used to initiate a Telnet client session with a specific Telnet server.
telnet [<ipaddr> | <domain_name 255>] {tcp_port(1) <value 0-65535>}
The Telnet command establishes a single Telnet client connection with a specified server.
The parameters specified by the command will only be used for the establishment of this
specific session. They will not affect the establishment of other sessions.
ipaddr - The IP address of the Telnet server.
domain_name - Specify the domain name of the Telnet server.
tcp_port - Specifies the Telnet server port number to be connected. If not specified, the
default port is 23.
None.
DGS-3627 Fast Ethernet Switch Command Line Interface
Firmware: Build 1.01-B03

TELNET CLIENT COMMANDS

683
93