D-Link xStack Reference Manual page 214

xStack
DGS-3627:admin# show dhcp_binding
Command:show dhcp_binding
Pool Name IP Address
----------- -----------
engineering 192.168.0.1
Total Entries : 1
DGS-3627:admin#
clear dhcp_binding
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the DHCP binding information on the Switch:
DGS-3627:admin# clear dhcp_binding
Command:clear dhcp_binding
Success.
DGS-3627:admin#
config dhcp ping_packets
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the number of ping packets to be used for DHCP:
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
Hardware Address
--------------------
01-22-b7-35-ce-99
Used to clear the DHCP binding information.
clear dhcp_binding {<pool_name 12>}
This command is used to clear the DHCP binding settings for a particular created DHCP pool.
<pool_name 12> − Enter the name of the DHCP pool for which to clear the binding
information.
Only Administrator and Operator-level users can issue this command.
Used to set the number of ping packets that will be sent out to find if an IP address is
available.
config dhcp ping_packets <number 2-10>
This command will set the number of ping packets that will be sent out to find if an IP address
is available to be allocated as a valid DHCP IP address.
<number 2-10> − Enter a number between 2 and 10 to denote the number of ping packets
that the Switch will send out on the network containing the IP address to be allotted. If the
ping request is not returned, the IP address is considered unique to the local network and
then allotted to the requesting client. The default setting is 2 packets.
Only Administrator and Operator-level users can issue this command.
Type Status
--------- --------- ----------------
Ethernet Manual
210
Life Time (secs)
864000