D-Link xStack Reference Manual page 320

xStack
DGS-3627:admin# disable igmp_snooping
Command: disable igmp_snooping
Success.
DGS-3627:admin#
create igmp_snooping static_group
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To create an IGMP snooping static group for VLAN 1, group 239.1.1.1:
DGS-3627:admin# create igmp_snooping static_group vlan vlan1 239.1.1.1
Command: create igmp_snooping static_group vlan vlan1 239.1.1.1
Success.
DGS-3627:admin#
delete igmp_snooping static_group
Purpose
Syntax
Description
Parameters
Restrictions
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
Used to configure an IGMP snooping multicast static group.
create igmp_snooping static_group [vlan<vlan_name 32> | vlanid <vlanid_list> ] <
ipaddr >
This command allows you to create an IGMP snooping static group. Member ports can be
added to the static group. The static member and the dynamic member port form the member
ports of a group.
The static group will only take effect when IGMP snooping is enabled on the VLAN. For those
static member ports, the device needs to emulate the IGMP protocol operation to the querier,
and forward the traffic destined to the multicast group to the member ports.
For a layer 3 device, the device is also responsible to route the packet destined for this
specific group to static member ports.
The static member port will only affect V2 IGMP operation.
The Reserved IP multicast address 224.0.0.X must be excluded from the configured group.
The VLAN must be created first before a static group can be created.
vlan_name - Specify the name of the VLAN on which the router port resides.
ipaddr - Specify the multicast group IP address (for Layer 3 switch).
Only Administrator and Operator-level users can issue this command.
Used to delete a IGMP snooping multicast static group.
delete igmp_snooping static_group [vlan<vlan_name 32> | vlanid <vlanid_list> ]
<ipaddr>
The deletion of an IGMP snooping static group will not affect the IGMP snooping dynamic
member ports for a group.
vlan - Specify the name of the VLAN on which the router port resides.
vlanid - Specify the ID of the VLAN on which the router port resides.
ipaddr - Specify the multicast group IP address (for Layer 3 switch).
Only Administrator and Operator-level users can issue this command.
316