D-Link xStack Reference Manual page 437

xStack
config loopback ipif
Description
Parameters
Restrictions
Example usage:
To configure the loopback interface named loopback1 with subnet address 10.0.0.1/8:
DGS-3627:admin# config loopback ipif loopback1 ipaddress 10.0.0.1/8
Command: config loopback ipif loopback1 ipaddress 10.0.0.1/8
Success.
DGS-3627:admin#
show loopback ipif
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To show the information of the loopback interface named loopback1:
DGS-3627:admin# show loopback ipif loopback1
Command: show loopback ipif loopback1
Loopback Interface
Interface Admin State
IPv4 Address
Total Entries:1
DGS-3627:admin#
delete loopback ipif
Purpose
Syntax
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
Configure the parameters for the loopback interface. For IPv4, only the system interface can
be specified for the way to get the IP address.
<ipif_name 12> - The name of the loopback interface .
Note: the loopback ipif has the same name domain space with the regular ipif, so its name
can't duplicate with the regular ipif.
network_address - IPv4 network address (xxx.xxx.xxx/xx) of the loopback interface. It
specifies a host address and length of network mask.
state - The state of loopback interface.
Only Administrator and Operator-level users can issue this command.
Show the information of the loopback interface.
show loopback ipif {< ipif_name 12 >}
To show the information of the loopback interface.
<ipif_name 12> - The name of the loopback interface.
Note: the loopback ipif has the same name domain space with the regular ipif, so its name
can't duplicate with the regular ipif.
None.
: loopback1
: Enabled
: 10.0.0.1/8 (MANUAL)
Delete the loopback interface.
delete loopback ipif [< ipif_name 12 > | all]
433