D-Link xStack Reference Manual page 747

xStack
config wac default_redirpath
Parameters
Restrictions
Example usage:
To config WAC default redirect URL:
DGS-3627:admin# config wac default_redirpath http://www.dlink.com
Command: config wac default_redirpath http://www.dlink.com
Success.
DGS-3627:admin#
config wac clear_default_redirpath
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To clear WAC default redirect URL:
DGS-3627:admin# config wac clear_default_redirpath
Success.
DGS-3627:admin#
config wac virtual_ip
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
Set IPv4 virtual IP address:
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
authentication.
string - The URL that the client will be redirected to after successful authentication. By
default, the redirected path is cleared
Only Administrator and Operator-level users can issue this command.
Used to clear WAC default redirect URL.
config wac clear_default_redirpath
When the string is cleared, the client will not be redirected to another URL after successful
authentication.
None.
Only Administrator and Operator-level users can issue this command.
Used to config the virtual IP address for WAC.
config wac virtual_ip { < ipaddr > | < ipv6addr > } (1)
The virtual IP of WAC is used to accept authentication request from unauthenticated host.
Only requests sent to this IP will get response correctly.
This IP does not respond to ARP request or ICMP packet!
ipaddr - To specify the IP address of the virtual IP.
ipv6addr - To specify the IPv6 address of the virtual IP.
Only Administrator and Operator-level users can issue this command.
743