D-Link xStack Reference Manual page 671

xStack
show syslog source_ipif
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
Show syslog source IP interface:
DGS-3627:admin# show syslog source_ipif
Command: show syslog source_ipif
Syslog Source IP Interface Configuration:
IP Interface
IPv4 Address
DGS-3627:admin#
config trap source_ipif
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
Configure trap source IP interface:
DGS-3627:admin# config trap source_ipif inter4
Command: config trap source_ipif inter4
Success
DGS-3627:admin#
To clear the configured trap source IP interface:
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
Show syslog source IP interface.
show syslog source_ipif
This command is used to display the syslog source IP interface.
None.
None.
: ipif3
: 14.0.0.3
Configure trap source IP interface.
config trap source_ipif [<ipif_name> {<ipaddr> | <ipv6addr>} | none]
This command is used to configure trap source IP interface.
ipif_name - IP interface name. If only specify this parameter, the least IPv4 address and the
smallest IPv6 address of ipif_name will be used as source IP addresses.
none - For clearing the configured source IP interface.
ipaddr - IPv4 address.
ipv6addr - IPv6 address.
Only Administrator and Operator-level users can issue this command.
667