D-Link xStack Reference Manual page 104

xStack
debug bgp packet
Restrictions
Example usage:
Configure BGP to display debugging information after it received update packets:
DGS-3627:admin# debug bgp packet all in enable
Command: debug bgp packet all in enable
Success.
DGS-3627:admin#
After the BGP peer FSM event debug flag is enabled, it may print following information:
BGP:Peer:<10.1.1.10> RCV OPEN, version:<4>,remote-as:<40>, HoldTime:<180>,RID:<16.0.0.1>
BGP:Peer:<10.1.1.10> RCV KEEPALIVE.
BGP:Peer:<10.1.1.10> RCV UPDATE, withdraw: <21.0.0.0/8>,<22.0.0.0/8>,<23.0.0.0/8>,
<24.0.0.0/8>,<25.0.0.0/8>...
BGP:Peer:<10.1.1.10> RCV UPDATE,attr:<Orign:i,As-path:10,Next-hop:10.1.1.10,Med:5>, NLRI:
<21.0.0.0/8>,<22.0.0.0/8>
BGP:Peer:<10.1.1.10> RCV NOTIFYCATION,Code:<OPEN Message Error.>,SubCode:<Bad Peer AS.>
BGP:Peer:<10.1.1.10> RCV REFRESH,afi:<1>,safi:<1>
BGP:Peer:<10.1.1.10> RCV Capability Action:Set,Code: GRST ,Length:2
debug bgp error
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
Configure BGP to enable the error debug flag:
DGS-3627:admin# debug bgp error state enable
Command: debug bgp error state enable
Success.
DGS-3627:admin#
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
Direction of packet:
in
out
enable - Enable the BGP debug function
disable - Disable the BGP debug function
Only Administrator level users can issue this command.
This command is used to set the flag of debugging information related to BGP errors, to not
send BGP notifications
debug bgp error state [enable | disable]
This command is used to set the flag of debugging information related to BGP errors, to not
send BGP notifications
enable - Enable the BGP debug function
disable - Disable the BGP debug function
Only Administrator level users can issue this command.
100