D-Link xStack Reference Manual page 9

xStack
In the above example, the command config account was entered without the required parameter <username>, the CLI
returned the Next possible completions: <username> prompt. The up arrow cursor control key was pressed to re-
enter the previous command (config account) at the command prompt. Now the appropriate username can be entered
and the config account command re-executed.
All commands in the CLI function in this way. In addition, the syntax of the help prompts are the same as presented in this
manual − angle brackets < > indicate a numerical value or character string, braces { } indicate optional parameters or a
choice of parameters, and brackets [ ] indicate required parameters.
If a command is entered that is unrecognized by the CLI, the top-level commands will be displayed under the Available
commands: prompt.
DGS-3627:admin# the
Available commands:
..
clear
debug
download
logout
reboot
save
traceroute6
DGS-3627:admin#
The top-level commands consist of commands such as show or config. Most of these commands require one or more
parameters to narrow the top-level command. This is equivalent to show what? or config what? Where the what? is the
next parameter.
For example, if you enter the create command with no additional parameters, the CLI will then display all of the possible
next parameters.
DGS-3627:admin# create
Command: create
Next possible completions:
802.1x
arpentry
authentication
dhcpv6
erps
ip
iproute
link_aggregation
mac_based_access_control_local
mirror
ospf
route
snmp
syslog
vrrp
DGS-3627:admin#
In the above example, all of the possible next parameters for the create command are displayed.
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
?
config
delete
enable
no
reconfig
show
upload
Figure 2- 5. Available Commands
access_profile
authen
bgp
dot1v_protocol_group
fdb
ip_tunnel
ipv6
loopback
multicast_fdb
ospfv3
route_map
stp
trusted_host
wac
Figure 2- 6. Next possible completions: Create command
cable_diag
copy
dir
erase
ping
rename
telnet
account
authen_enable
cpu
host_name
ipif
ipv6route
mac_based_access_control
mac_based_vlan
multicast_range
pim
rspan
subnet_vlan
vlan
5
cd
create
disable
login
ping6
reset
traceroute
address_binding
authen_login
dhcp
double_vlan
igmp_snooping
ipmroute
jwac
md5
nlb
policy_route
sflow
super_vlan
vlan_translation