D-Link xStack Reference Manual page 491

xStack
config ospfv3 router_id
Parameters
Restrictions
Example usage:
To set OSPFv3 router ID:
DGS-3627:admin# config ospfv3 router_id 1.1.1.1
Command: config ospfv3 router_id 1.1.1.1
Success.
DGS-3627:admin#
enable ospfv3
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable OSPFv3:
DGS-3627:admin# enable ospfv3
Command: enable ospfv3
Success.
DGS-3627:admin#
disable ospfv3
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To disable OSPFv3:
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
router_id - User may enter a 32-bit number in the form of an IPv4 address that uniquely
identifies the router in the OSPFv3 domain. Set 0.0.0.0 means auto-selected. Switch will
select the largest IPv4 address among the IP interfaces to be the router ID. The default value
of OSPFv3 router ID is 0.0.0.0 (auto-selected).
Only Administrator and Operator-level users can issue this command.
Used to enable OSPFv3 on the switch.
enable ospfv3
This command is used to enable OSPFv3 on the switch.
None.
Only Administrator and Operator-level users can issue this command.
Used to disable OSPFv3 on the switch.
disable ospfv3
This command is used to disable OSPFv3 on the switch.
None.
Only Administrator and Operator-level users can issue this command.
487