D-Link xStack Reference Manual page 20

xStack
enable web
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable HTTP and configure port number:
DGS-3627:admin# enable web 80
Command: enable web 80
Note: SSL will be disabled if web is enabled.
Success.
DGS-3627:admin#
disable web
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To disable HTTP:
DGS-3627:admin# disable web
Command: disable web
Success.
DGS-3627:admin#
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
Used to enable the HTTP-based management software on the Switch.
enable web {<tcp_port_number 1-65535>}
This command is used to enable the Web-based management software on the Switch. The
user can specify the TCP port number the Switch will use to listen for Telnet requests.
{<tcp_port_number 1-65535>} − The TCP port number. TCP ports are numbered between 1
and 65535. The "well-known" port for the Web-based management software is 80.
Only Administrator and Operator-level users can issue this command.
Used to disable the HTTP-based management software on the Switch.
disable web
This command disables the Web-based management software on the Switch.
None.
Only Administrator and Operator-level users can issue this command.
16