D-Link xStack Reference Manual page 612

xStack
config safeguard_engine
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the safeguard engine for the Switch:
DGS-3627:admin# config safeguard_engine state enable utilization rising 45
Command: config safeguard_engine state enable utilization rising 45
Success.
DGS-3627:admin#
show safeguard_engine
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
To config ARP storm control for system.
config safeguard_engine {state [enable | disable] | utilization {rising <value 20-
100> | falling <value 20-100>} | trap_log [enable | disable] | mode [strict | fuzzy]}
Use this command to configure Safeguard Engine to minimize the effects of an ARP
storm.
state [enable | disable] – Select the running state of the Safeguard Engine function as
enable or disable.
utilization – Select this option to trigger the Safeguard Engine function to enable based
on the following determinates:
•
rising <value 20-100> – The user can set a percentage value of the rising CPU
utilization which will trigger the Safeguard Engine function. Once the CPU
utilization rises to this percentage, the Safeguard Engine mechanism will
initiate.
•
falling <value 20-100> – The user can set a percentage value of the falling
CPU utilization which will trigger the Safeguard Engine function to cease. Once
the CPU utilization falls to this percentage, the Safeguard Engine mechanism
will shut down.
trap_log [enable | disable] – Choose whether to enable or disable the sending of
messages to the device's SNMP agent and switch log once the Safeguard Engine has
been activated by a high CPU utilization rate.
mode - Used to select the type of Safeguard Engine to be activated by the Switch when
the CPU utilization reaches a high rate. The user may select:
•
strict – If selected, this function will stop accepting all ARP packets not
intended for the Switch, and will stop receiving all unnecessary broadcast IP
packets, until the storm has subsided.
•
fuzzy – If selected, this function will instruct the Switch to minimize the IP and
ARP traffic flow to the CPU by dynamically allotting an even bandwidth to all
traffic flows.
Only Administrator and Operator-level users can issue this command.
Used to display current Safeguard Engine settings.
show safeguard_engine
This will list the current status and type of the Safeguard Engine settings currently
configured.
None.
None.
608