Simple Network Management Protocol (Snmp) Commands - D-Link xStack Reference Manual

xStack
SIMPLE NETWORK MANAGEMENT PROTOCOL (SNMP)
The Simple Network Management Protocol (SNMP) commands in the Command Line Interface (CLI) are listed (along
with the appropriate parameters) in the following table.
Command
create snmp community
delete snmp community
show snmp community
create snmp user
delete snmp user
show snmp user
create snmp group
delete snmp group
show snmp groups
create snmp view
delete snmp view
show snmp view
create snmp
delete snmp
show snmp host
show snmp v6host
config snmp engineID
show snmp engineID
Each command is listed, in detail, in the following sections.
create snmp community view
Purpose
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
Parameters
<community_string 32> view <view_name 32> [read_only | read_write]
<community_string 32>
{ <community_string 32> }
<user_name 32> <groupname 32> {encrypted [by_password auth [ md5
<auth_password 8-16 > | sha <auth_password 8-20 >] priv [none | des
<priv_password 8-16>] | by_key auth [md5 <auth_key 32-32> | sha <auth_key
40-40>] priv [none | des <priv_key 32-32>]]}
<user_name 32>
<groupname 32> [v1 | v2c | v3 [noauth_nopriv | auth_nopriv | auth_priv]]
{read_view <view_name 32> | write_view <view_name 32> | notify_view
<view_name 32>}
<groupname 32>
<view_name 32> <oid> view_type [included | excluded]
<view_name 32> [all | <oid>]
{<view_name 32>}
[ host <ipaddr> | v6host <ipv6addr>] [v1 | v2c | v3 [noauth_nopriv | auth_nopriv |
auth_priv] ] <auth_string 32>
[host <ipaddr> | v6host <ipv6addr>]
{ <ipaddr> }
{ <ipv6addr> }
<snmp_engineID 10-64>
Use an SNMP community string to define the relationship between the SNMP manager and
the agent. The community string acts like a password to permit access to the agent on the
switch. You can specify one or more of the following characteristics associated with the
string:
630
83
COMMANDS