D-Link xStack Reference Manual page 678

xStack
create syslog host
Restrictions
Example usage:
To create a new syslog host:
DGS-3627:admin# create syslog host 1 ipaddress 10.90.90.1 severity all facility local0
Command: create syslog host 1 ipaddress 10.90.90.1 severity all facility local0
Success.
DGS-3627:admin#
delete syslog host
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To delete a syslog host:
DGS-3627:admin# delete syslog host 4
Command: delete syslog host 4
Success.
DGS-3627:admin#
show syslog host
Purpose
Syntax
Description
Parameters
Restrictions
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
local6
local7
udp_port - The UDP port number.
state - The syslog protocol is used for the transmission of event notification messages across
networks to a host. This option enables or disables the hosts that will receive such
messages.
ipaddress – Specify the IP address used here.
Only Administrator and Operator-level users can issue this command.
Used to delete the syslog host(s).
delete syslog host [<index 1-4> | all]
This command deletes the syslog host(s).
When the specified host doesn't exist, the prompt message, "The entry does not exist," will
be displayed and this configuration will fail.
host [ <index 1-4> | all ] - Host index or all hosts.
Only Administrator and Operator-level users can issue this command.
Used to display syslog host configurations.
show syslog host {<index 1-4>}
This command displays the syslog host configurations.
index - The host index.
If no parameter is specified, all hosts will be displayed.
None.
user-defined facility
user-defined facility
674