D-Link xStack Reference Manual page 280

xStack
config erps trap
Restrictions
Example usage:
To configure the trap state of the ERPS:
DGS-3627:admin# config erps trap enable
Command: config erps trap enable
Success.
DGS-3627:admin#
config erps raps_vlan state
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the ring state of the ERPS:
DGS-3627:admin# config erps raps_vlan state enable
Command: config erps raps_vlan state enable
Success.
DGS-3627:admin#
config erps raps_vlan sub_ring
Purpose
Syntax
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
Only Administrator and Operator-level users can issue this command.
Used to configure the state of the specified ring.
config erps raps_vlan <vlanid> state [enable | disable]
This command is used to configure ring state of the specified ring. When both the global state
and the specified ring ERPS state are enabled, the specified ring will be activated. STP and
LBD should be disabled on the ring ports before the specified ring is activated.
The ring cannot be enabled before the R-APS VLAN is created, and ring ports, RPL port,
RPL owner, are configured. Note that these parameters cannot be changed when the ring is
activated.
In order to guarantee correct operation, the following integrity will be checked when the ring
is enabled and the global ERPS state is enabled.
R-APS VLAN is created.
The Ring port is the tagged member port of the R-APS VLAN.
The RPL port is specified if RPL owner is enabled.
The default state of the ring is disabled.
state - See below:
enable - Enable the state of the specified ring.
disable - Disable the state of the specified ring.
The default value is disabled.
Only Administrator and Operator-level users can issue this command.
Used to configure a sub-ring connected to another ring.
config erps raps_vlan <vlanid> [add | delete] sub_ring raps_vlan <vlanid>
276