D-Link xStack Reference Manual page 707

xStack
DGS-3627:admin# show traffic control 1-10
Command: show traffic control 1-10
Traffic Control Trap
Traffic Control Auto Recover Time
Port Thres Broadcast Multicast Unicast
hold Storm
---- ------ --------- --------- -------- -------- ----- -------- --------
1 1 Enabled
2 1 Enabled
3 1 Enabled
4 1 Enabled
5 1 Enabled
6 1 Enabled
7 1 Enabled
8 1 Enabled
9 1 Enabled
10 1 Enabled
DGS-3627:admin#
config traffic control auto_recover_time
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the auto recover time to 5 minutes:
DGS-3627:admin# config traffic control auto_recover_time 5
Command: config traffic control auto_recover_time 5
Success.
DGS-3627:admin#
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
Storm Storm
Disabled Disabled Shutdown 5
Disabled Disabled Shutdown 5
Disabled Disabled Shutdown 5
Disabled Disabled Shutdown 5
Disabled Disabled Shutdown 5
Disabled Disabled Shutdown 5
Disabled Disabled Shutdown 5
Disabled Disabled Shutdown 5
Disabled Disabled Shutdown 5
Disabled Disabled Shutdown 5
Used to configure the traffic auto recover time used to specify the time allowed for a port to
recover from shutdown forever status.
config traffic control auto_recover_time [<min 0> | <min 1-65535>]
Configure all ports' auto recover time from shutdown forever state.
minutes - The time allowed for auto recovery from shutdown for a port. The default value is 0,
so no auto recovery is possible; the port remains in shutdown forever mode. This requires
manual entry of the CLI command "config ports [ <portlist> | all ] state enable" to return the
port to a forwarding state.
The default value is 0, which means disable auto recover mode, shutdown forever.
Only Administrator and Operator-level users can issue this command.
: [None]
: 5 Minutes
Action Count
down
703
Time Shutdown
Interval Forever
10
10
10
10
10
10
10
10
10
10