Border Gateway Protocol (Bgp) Commands - D-Link xStack Reference Manual

xStack

BORDER GATEWAY PROTOCOL (BGP) COMMANDS

The Border Gateway Protocol (BGP) commands in the Command Line Interface (CLI) are listed (along with the
appropriate parameters) in the following table.
Command
enable bgp
disable bgp
create bgp
delete bgp
config bgp router_id
config bgp synchronization
config bgp enforce_first_as
create bgp aggregate_address
delete bgp aggregate_address
show bgp aggregate_address
create bgp network
config bgp network
delete bgp network
show bgp network
config bgp timer
config bgp
config bgp dampening
show bgp dampening
config bgp peer_group
config bgp peer_group
create bgp neighbor
delete bgp neighbor
config bgp neighbor description
config bgp neighbor session
config bgp neighbor session
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
Parameters
<as_number 1-65535>
<as_number 1-65535>
<ipaddr>
[enable | disable]
[enable | disable]
<network_address> {summary_only | as_set}
[<network_address>| all]
{<network_address>]
<network_address> {route_map <map_name 16>}
<network_address> [route_map <map_name 16> | clear_routemap]
[<network_address> | all]
{<network_address>}
holdtime <sec 0-65535> keepalive <sec 0-65535>
{ always_compare_med [enable | disable]| deterministic_med [enable | disable] |
default_local_preference <uint 0-4294967295>| bestpath { as_path_ignore
[enable | disable] | compare_routerid [enable | disable] | med_confed [enable |
disable] | med_missing_as_worst [enable | disable] | compare_confed_aspath
[enable | disable] }(1)}(1)
[ route_map <map_name 16> | clear_routemap | { state [enable | disable] |
half_life <min 1-45 > | reuse<value 1-20000> | suppress <value 1-20000> |
max_suppress_time <min 1-255 >| un_reachability_half_life <min 1-45>}(1)]
<peer_group_name 16> [add | delete] <ipaddr>
<peer_group_name 16> remote_as <as_number 0-65535>
[<ipaddr> [remote_as <as_number 1-65535>| peer_group <peer_group_name
16>] | peer_group <peer_group_name 16>]
[<ipaddr> | peer_group <peer_group_name 16> | all]
[<ipaddr> | peer_group <peer_group_name 16>] [description <desc 80> |
clear_description]
[<ipaddr> | peer_group <peer_group_name 16>] state [enable | disable]
[<ipaddr> | peer_group <peer_group_name 16>] activity [enable | disable]
111
14