Vrrp Debug Commands - D-Link xStack Reference Manual

xStack
The VRRP Debug commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in
the following table.
Command
debug vrrp show flag
debug vrrp vr_state_change state
debug vrrp packet
debug vrrp mac_addr_update state
debug vrrp interface_change state
debug vrrp timers state
debug vrrp show counter
debug vrrp clear counter
debug vrrp log state
debug vrrp show log state
debug vrrp state
Each command is listed, in detail, in the following sections.
debug vrrp show flag
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display VRRP debug flag settings:
DGS-3627:admin# debug vrrp show flag
Command: debug vrrp show flag
Current VRRP Debug Level Settings
Virtual Router State Change
Packet Sending
DGS-3627:admin#
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
Parameters
[enable | disable]
[all | {receiving | sending}(1)] state [enable | disable]
[enable | disable]
[enable | disable]
[enable | disable]
[enable | disable]
[enable | disable]
Used to display VRRP debug flag settings.
debug vrrp show flag
This command is used to display VRRP debug flag settings.
None.
Only Administrator level users can issue this command.

VRRP DEBUG COMMANDS

728
104