D-Link xStack Reference Manual page 645

xStack
show snmp v6host
Parameters
Restrictions
Example usage:
To show SNMP host:
DGS-3627:admin# show snmp v6host
Command: show snmp v6host
SNMP Host Table
------------------------------------------------------------------
Host IPv6 Address : 3FFE::3
SNMP Version
Community Name/SNMPv3 User Name : initial
Host IPv6 Address : 3FFE::2
SNMP Version
Community Name/SNMPv3 User Name : private
Host IPv6 Address : 3FFE::1
SNMP Version
Community Name/SNMPv3 User Name : public
Host IPv6 Address : 3FFE::3
SNMP Version
Community Name/SNMPv3 User Name : user123
Host IPv6 Address : 3FFE::3
SNMP Version
Community Name/SNMPv3 User Name : user234
Total Entries: 5
DGS-3627:admin#
config snmp engineID
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure SNMP engine ID to "1023457890":
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
Note: This is SNMPv3 command, if it is used; All SNMPv1/v2 commands are not necessary.
v6host - Specifies the IPv6 host address.
If no parameter specified, all SNMP hosts will be displayed.
None.
: V3 na/np
: V2c
: V1
: V3 a/np
: V3 a/ p
This command is used to configure a identifier for the SNMP engine on the switch.
config snmp engineID <snmp_engineID>
The config snmp engineID command configures an identifier for the SNMP engine on the
switch. Associated with each SNMP entity is a unique engineID.
Note: This is SNMPv3 command, if it is used; All SNMPv1/v2 commands are not necessary.
snmp_engineID - Identify for the SNMP engine on the switch. It is octet string type. It accepts
the hex number directly.
Only Administrator and Operator-level users can issue this command.
641