Counter Commands - D-Link xStack Reference Manual

xStack
The Counter commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command
show packet ports
show error ports
show utilization ports
clear counters
Each command is listed, in detail, in the following sections.
show packet ports
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the packets analysis for port 7 of unit 2:
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
Parameters
<portlist>
<portlist>
{ports <portlist>}
Used to show statistics about the packets which were sent and received by the switch.
show packet ports <portlist>
The show packet ports command shows statistics about the packets which were sent and
received by the switch.
portlist - Specifies a range of ports to be displayed. (Unit ID: port number).
None.

COUNTER COMMANDS

179
21