D-Link xStack Reference Manual page 565

xStack
show pim ipmroute
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To view the PIM routes:
DGS-3627:admin# show pim ipmroute
Command: show pim ipmroute
PIM IP Multicast Route Table
UA = Upstream AssertTimer
AM = Assert Metric
AMPref = Assert MetricPref
ARB = Assert RPTBit
Group Address
------------------ ------------------ ------ ------ ------ ------ ----
224.0.1.1
224.0.1.24
224.0.1.24
224.0.1.24
229.55.150.208
229.55.150.208
229.55.150.208
229.55.150.208
229.55.150.208
229.55.150.208
229.55.150.208
239.192.0.1
Total Entries: 12
DGS-3627:admin#
create pim register_checksum_include_data
Purpose
Syntax
Description
Parameters
Restrictions
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
Used to display the PIM IP Multicast Route Table on the Switch.
show pim ipmroute
This command will display the PIM IP Multicast Route Table on the Switch. This
command is for PIM-SM configurations only.
None.
None.
Source Address
31.43.51.81/32
10.54.81.250/32
10.55.68.64/32
31.43.51.81/32
10.6.51.1/32
10.38.45.151/32
10.38.45.192/32
10.50.93.100/32
10.51.16.1/32
10.59.23.10/32
31.43.51.81/32
31.43.51.81/32
Used to set the RPs that the Switch will send Register packets to and create
checksums to be included with the data in Registered packets.
create pim register_checksum_include_data rp_address <ipaddr>
This command will set the RPs that the Switch will send Register packets to and
create checksums to be included with the data in Registered packets. This
command is for PIM-SM configurations only.
rp_address <ipaddr> − Enter the IP address of the RP that will verify checksums
included with Registered packets.
Only Administrator and Operator-level users can issue this command.
UA AM AMPref ARB
0 0 0
0 0 0
0 0 0
0 0 0
0 0 0
0 0 0
0 0 0
0 0 0
0 0 0
0 0 0
0 0 0
0 0 0
561
Flag Type
-------
0 RPT (*.G)
0 SPT (S.G)
0 SPT (S.G)
0 RPT (*.G)
0 SPT (S.G)
0 SPT (S.G)
0 SPT (S.G)
0 SPT (S.G)
0 SPT (S.G)
0 SPT (S.G)
0 RPT (*.G)
0 RPT (*.G)