D-Link xStack Reference Manual page 495

xStack
DGS-3627:admin# show ospfv3 area
Command: show ospfv3 area
OSPFv3 Area Settings
Area ID Type
--------------- ------ ----------------------- -----------------
0.0.0.0 Normal None
2.2.2.2 Normal None
Total Entries: 2
DGS-3627:admin# show ospfv3 area 0.0.0.0
Command: show ospfv3 area 0.0.0.0
Area ID: 0.0.0.0
SPF Algorithm Runs For Area 0.0.0.0: 1 time
Number Of LSA In This Area: 2
Number Of ABR In This Area: 0
Total Entries: 1
DGS-3627:admin#
create ospfv3 aggregation
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To create an OSPFv3 area aggregation:
DGS-3627:admin# create ospfv3 aggregation 2.2.2.2 2000::/16 advertise enable
Command: create ospfv3 aggregation 2.2.2.2 2000::/16 advertise enable
Success.
DGS-3627:admin#
delete ospfv3 aggregation
Purpose
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
Stub Import Summary LSA Stub Default Cost
Used to create an OSPFv3 area aggregation.
create ospfv3 aggregation <area_id> <ipv6networkaddr> advertise [enable | disable]
This command is used to create an OSPFv3 area aggregation.
<area_id> - Specify the area where the aggregation belongs to.
<ipv6networkaddr> - Specify the IPv6 network address of the aggregation.
advertise - See below:
enable - OSPFv3 ABR will use this aggregation to aggregate the intra-area routes
when it advertise these routes to another area.
disable - OSPFv3 ABR will not use this aggregation to aggregate the intra-area
routes when it advertise these routes to another area.
Only Administrator and Operator-level users can issue this command.
Used to delete an OSPFv3 area aggregation.
None
None
Area Type: Normal
Checksum Sum: 0x0
Number Of ASBR In This Area: 0
491