D-Link xStack Reference Manual page 505

xStack
Each command is listed, in detail, in the following sections.
config ospf router_id
Purpose
Syntax
Description
Parameters
Restrictions
Usage example
To configure the OSPF router ID:
DGS-3627:admin# config ospf router_id 10.48.74.122
Command: config ospf router_id 10.48.74.122
Success.
DGS-3627:admin#
enable ospf
Purpose
Syntax
Description
Parameters
Restrictions
Usage example
To enable OSPF on the Switch:
DGS-3627:admin# enable ospf
Command: enable ospf
Success.
DGS-3627:admin#
disable ospf
Purpose
Syntax
Description
Parameters
Restrictions
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
Used to configure the OSPF router ID.
config ospf router_id <ipaddr>
This command is used to configure the OSPF router ID.
<ipaddr> − The IP address of the OSPF router.
Only Administrator and Operator-level users can issue this command.
Used to enable OSPF on the Switch.
enable ospf
This command, in combination with the disable ospf command below, is used to enable and
disable OSPF on the Switch.
None.
Only Administrator and Operator-level users can issue this command.
Used to disable OSPF on the Switch.
disable ospf
This command, in combination with the enable ospf command above, is used to enable and
disable OSPF on the Switch.
None.
Only Administrator and Operator-level users can issue this command.
501