D-Link xStack Reference Manual page 40

xStack
DGS-3627:admin# config 802.1x fwd_pdu system enable
Command: config 802.1x fwd_pdu system enable
Success.
DGS-3627:admin#
config 802.1x fwd_pdu ports
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure 802.1X fwd_pdu for ports:
DGS-3627:admin# config 802.1x fwd_pdu ports 1,2 enable
Command: config 802.1x fwd_pdu
Success.
DGS-3627:admin#
config 802.1x authorization network radius
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
The following example will disable to accept the authorized data assigned from the RADIUS server:
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
Used to configure if the port will flood EAPOL PDU when 802.1X functionality is disabled.
config 802.1x fwd_pdu ports [ < portlilst > | all ] [ enable | disable ]
This is a per port setting to control the forwarding of EAPOL PDU. When 802.1X functionality
is disabled globally or for a port, and if 802.1X fwd_pdu is enabled both globally and for the
port, a received EAPOL packet on the port will be flooded in the same VLAN to those ports
for which 802.1X fwd_pdu is enabled and 802.1X is disabled (globally or just for the port).
The default state is disabled.
ports - Specifies a range of ports to be configured.
all - All ports.
enable - Enable forwarding EAPOL PDU receive on the ports.
disable - Disable forwarding EAPOL PDU receive on the ports.
Only Administrator and Operator-level users can issue this command.
ports 1,2 enable
The enable or disable the acceptation of an authorized configuration.
config 802.1x authorization network radius [ enable | disable ]
The command config 802.1x authorization attributes is used to enable or disable the
acception of authorized configuration.
When the authorization is enabled for 802.1X's RADIUS authentication, the authorized
attributes assigned by the RADUIS server will be accepted if the global authorization status is
enabled.
radius - If specified to enable, the authorization attributes assigned by the RADUIS server will
be accepted if the global authorization status is enabled. The default state is enabled.
Only Administrator and Operator-level users can issue this command.
36