D-Link xStack Reference Manual page 492

xStack
DGS-3627:admin# disable ospfv3
Command: disable ospfv3
Success.
DGS-3627:admin#
show ospfv3
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display OSPFv3 configuration for System:
DGS-3627:admin# show ospfv3 ipif System
Command: show ospfv3 ipif System
Interface Name: System
Up)
Network Medium Type: BROADCAST
Area ID: 0.0.0.0
Priority: 1
DR ID: None
Hello Interval: 10
Transmit Delay: 1
Passive Mode: Disabled
Total Entries: 1
DGS-3627:admin#
create ospfv3 area
Purpose
Syntax
Description
Parameters
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
Used to display the OSPFv3 configurations or OSPFv3 interfaces information.
show ospfv3 {[ipif <ipif_name 12> | all]}
This command is used to display OSPFv3 configurations, including global state, router ID,
OSPFv3 interfaces, areas, virtual links and area aggregations. If the parameter is set, it is
used to display the information of one or all OSPFv3 interfaces.
ipif - Display the information of one OSPFv3 interface.
all - Display the information off all OSPFv3 interfaces.
None.
Used to create an OSPFv3 area.
create ospfv3 area <area_id> type [normal | stub {stub_summary [enable | disable] |
metric <value 0-65535>}]
This command is used to create an OSPFv3 area.
area - Specifies the OSPFv3 area's ID. It is a 32-bit number in the form of an IPv4 address
that uniquely identifies the OSPFv3 area in the OSPFv3 domain.
type - The OSPFv3 area mode of operation. There are two types:
normal - Define the OSPFv3 area created as a normal area.
stub - Define the OSPFv3 area created as a stub area.
stub_summary - Specifies the OSPFv3 stub area to import inter-area prefix LSA
advertisements or not.
Link Local Address: FE80::201:2FF:FE03:400 (Link
Metric: 10
Administrative State: Disabled
DR State: DOWN
Backup DR ID: None
Dead Interval: 40
Retransmit Time: 5
Instance ID: 0
488