Time And Sntp Commands - D-Link xStack DES-3526 Cli Manual

DES-3526 / DES-3526DC Layer 2 Fast Ethernet Switch CLI Reference Manual

Time and SNTP Commands

The Simple Network Time Protocol (SNTP) (an adaptation of the Network Time Protocol (NPT)) commands in the Command
Line Interface (CLI) are listed (along with the appropriate parameters) in the following table.
Command
config sntp
show sntp
enable sntp
disable sntp
config time
config time_zone
config dst
show time
Each command is listed, in detail, in the following sections.
config sntp
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
Parameters
{primary <ipaddr> | secondary <ipaddr> | poll-interval <int 30-
99999>}
<date ddmmmyyyy > <time hh:mm:ss >
{operator [+ | -] | hour <gmt_hour 0-13> | min <minute 0-59>}
[disable | repeating {s_week <start_week 1-4,last> | s_day
<start_day sun-sat> | s_mth <start_mth 1-12> | s_time <start_time
hh:mm> | e_week <end_week 1-4,last> | e-day <end_day sun-sat> |
e_mth <end_mth 1-12> | e_time <end_time hh:mm> | offset [30 | 60
| 90 | 120]} | annual {s_date <start_date 1-31> | s_mth <start_mth
1-12> | s_time <start_time hh:mm> | e_date <end_date 1-31> |
e_mth <end_mth 1-12> | e_time <end_time hh:mm> | offset [30 | 60
| 90 | 120]}]
Used to setup SNTP service.
config sntp {primary <ipaddr> | secondary <ipaddr> | poll-
interval <int 30-99999>}
Use this command to configure SNTP service from an SNTP server.
SNTP must be enabled for this command to function (See enable
sntp).
primary − This is the primary server the SNTP information will be
taken from.
<ipaddr> − The IP address of the primary server.
secondary − This is the secondary server the SNTP information will
be taken from in the event the primary server is unavailable.
<ipaddr> − The IP address for the secondary server.
poll-interval <int 30-99999> − This is the interval between requests
for updated SNTP information. The polling interval ranges from 30 to
99,999 seconds.
Only administrator-level users can issue this command. SNTP
service must be enabled for this command to function (enable sntp).
156
26